1. Home
  2. Phone Accessories
  3. Samsung S10, S10 Plus, Note 10, Note 10 Pro S20, S20 Plus and S20 Ultra High Quality Autobot UV Nano Optics Glass protector with Support for Ultrasonic in-display fingerprint ID

Samsung S10, S10 Plus, Note 10, Note 10 Pro S20, S20 Plus and S20 Ultra High Quality Autobot UV Nano Optics Glass protector with Support for Ultrasonic in-display fingerprint ID

Write a Review
On sale: Sh3,500.00 Sh2,750.00
Part Number: 143
Availability: In Stock. Free Shipping.

Choose Options

*

Features:

1 9H hardness and anti scratch

2 Glass is whole transparent and no black border, will show HD display

3 Qleophobic coating will make it anti fingerprint and touch smoothly

4 As it is full glue screen protector , it will have no touch issues

5 The case friendly and full cover glass will suit for almost all phone cases

6 Good quality but reasonable price

 

It should take more patient to install the glass protector:

Step 1 : Clean the screen with the wet wipe and cloth and removing any case from you phone

Step 2 : Stick the key hole with a label,and then use a knife or scissor open the liquid adhesive box,drop it on the screen(It is recommended that the glue be poured completely.The glue that drops on the screen can't have air bubbles, if there is air bubble, use the needle to pierce the air bubble to let go air. )

Step 3 : Peel off  the mask film from the glass,then place the screen protector to a suitable position on your deviceSLOWLYPLEASE DO NOT LIFT AND PRESS THE GLASS TO LET THE ADHESIVE SPREAD,JUST LET IT AUTOMATIC DISPERSION.(Very important)

Step 4 : Wait for about half a minute to let the adhesive spread and level.

Step 5 : If the adhesive overflow, wipe off with a clean cloth. After checking the retention criteria for the mobile phone's tempered film, the lamp was turned back and forth several times around the edge of the phone, and after 3 seconds of initial curing (not in the middle), the edge glue was wiped again until the glue overflowed. (Prevent white edges or long bubbles on edges)

Step 6 : Wait for the exhaust to complete, after the glue overflows cleanly, after the positioning standard of the tempered film is satisfied, turn on the light. Otherwise scrapped material.

Step 7 : Irradiate the mobile phone under UV lamp and need to illuminate twice for about 3 minutes to reach the fully-cured position.

Step 8 : Clear the screen,and turn off the UV lamp for reuse.

Step 9:Re-enroll fingerprint.

 

Related Items

Samsung Galaxy Note 4 Stardard Battery 3220Mah
Sh2,500.00 Sh1,750.00 Sale
In Stock.

Browse Similar Items

Recently Viewed Items

TOP